
Basin leaks
Water level drop with no obvious cause
Precise leak location on private pools, hotels, residences and special basins.

Water level drop with no obvious cause

Liners, tiles, joints and fittings

Skimmers, drains, pipes and plant rooms

Waterproofing defects and circulation losses

Leaks on pipes, fittings and equipment
A pool combines the basin, fittings and buried pipes: each area has its own detection method.

Inspection of skimmers, jets, main drain and lights, without draining.

Dye placed next to fittings to see where water is drawn out.

Each pipe (suction, return, main drain) is tested one by one.

Locates leaks on pipes buried under the deck and slab.

Listening to pipes and basin to pinpoint the leak.

Internal inspection of the pool pipework.

Detects punctures in the liner or reinforced membrane.

Spots damp areas around the basin and in the plant room.
A few real cases handled by our teams, taken from our intervention reports.
PoolWater was seeping out between the tiles and a coping stone whenever the pool was running. Pressure testing and tracer gas located an embedded leak on the return line, inside the pool wall.
PoolThe water level dropped every day and water was running at the foot of a wall. Each line was tested in turn, then a camera inspection revealed a break on the return line, under the slab.
PoolThe water level was dropping with no visible leak. With every line watertight, fluorescein dye revealed sealing defects around a return inlet and the main drain.
Aquatic centreThe main-drain lines and their collector were tested with tracer gas, manhole by manhole. Three of the four lines were cleared, and the report sets out the tests still needed on the large-diameter sections.
PoolThe pool's return line had already leaked twice before. Tracer gas located a new buried leak in the garden, opposite the ladder, without breaking the ground.
PoolThe level dropped, then stabilised between the skimmers and the lights. After ruling out any leak on the technical lines, a vacuum-bell test and fluorescein located the defect at the cable gland of a pool light.
PoolThe level dropped every day to about 40 cm below the waterline. With the lines watertight, fluorescein revealed four defects: a skimmer seal and three cracks in the walls.